As an efficient and stable construction machine, Liugong loader is widely used in various job scenarios. For operators who are new to LiuGong loaders, there may be some problems, such as the position of the actuation switch. So, where is the start switch of Liugong loader? This article will answer you in detail.
First of all, the start switch of the LiuGong loader is usually located inside the cab, and the exact position may vary from model to model. Generally, the start switch is located on the control panel on the left or right side of the driver's seat, and possibly near the dashboard under the steering wheel. The operator can pinpoint the position of the actuation switch by looking at the markings on the control panel or by referring to the user manual.
Once the start switch is found, the operator needs to follow the correct steps. First, make sure that all levers and switches of the loader are in the neutral or closed position. Then, insert the key into the start switch and gently turn to the "ON" position, at which point the indicator light on the instrument cluster will illuminate to indicate that the power is on. Next, press the clutch pedal and put the gear lever in neutral. Finally, gently turn the key to the "START" position to start the loader's engine.
It should be noted that during the start-up process, the operator should keep the key in the "START" position for no more than 3 seconds to avoid damage to the starter motor. At the same time, if you find that it is difficult to start or the engine cannot operate normally, you should stop the operation immediately and check whether the battery level, fuel supply and other systems are normal.
In short, understanding the position of the Liugong loader start switch and the correct operation method are the key to ensuring the normal operation of the loader. Through the introduction of this article, it is believed that the operator can better grasp the starting skills of the loader and improve the work efficiency and safety.
